

CORE Generator Options:
   Target Device              : xc6slx16-csg324
   Speed Grade                : -2
   HDL                        : verilog
   Synthesis Tool             : ISE

MIG Output Options:
   Component Name             : mig
   No of Controllers          : 1
   Hardware Test Bench           : enabled

    
/*******************************************************/
/*                  Controller 3                       */
/*******************************************************/
Controller Options : 
   Memory                  : DDR2_SDRAM
   Design Clock Frequency  : 3200 ps (312.50 MHz)
   Memory Type             : Components
   Memory Part             : EDE1116ACBG-8E
   Equivalent Part(s)      : EDE1116ACBG-8E
   Row Address             : 13
   Column Address          : 10
   Bank Address            : 3
   Data Mask               : enabled

Memory Options :
   Burst Length                       : 8(011)
   CAS Latency                        : 5
   DQS# Enable                        : Enable
   DLL Enable                         : Enable-Normal
   OCD Operation                      : OCD Exit
   Output Drive Strength              : Fullstrength
   Outputs                            : Enable
   Additive Latency (AL)              : 0
   RDQS Enable                        : Disable
   RTT (nominal) - ODT                : 50ohms       
   High Temparature Self Refresh Rate : Disable

User Interface Parameters :
   Configuration Type     : One 128-bit bi-directional port
   Ports Selected         : Port0
   Memory Address Mapping : ROW_BANK_COLUMN

   Arbitration Algorithm  : Round Robin

   Arbitration            : 
      Time Slot0 : 0
      Time Slot1 : 0
      Time Slot2 : 0
      Time Slot3 : 0
      Time Slot4 : 0
      Time Slot5 : 0
      Time Slot6 : 0
      Time Slot7 : 0
      Time Slot8 : 0
      Time Slot9 : 0
      Time Slot10: 0
      Time Slot11: 0

FPGA Options :
   Class for Address and Control       : II
   Class for Data                      : II
   Memory Interface Pin Termination    : CALIB_TERM
   DQ/DQS                              : 25 Ohms
   Bypass Calibration                  : enabled
   Debug Signals for Memory Controller : Disable
   Input Clock Type                    : Differential 
    